Oven, Microwave & Cooktop Error Codes

Electric cooking appliances require high-voltage safety and accurate temperature monitoring. Access our bench diagnostics for bake elements, RTD sensors, and induction generator boards.

Search & Filter by BrandOvens, Microwaves & Cooktops

Showing all 6 codes
Brands:

All Ovens, Microwaves & Cooktops Error Codes

WhirlpoolCritical
F3E0

Oven Temperature Sensor (RTD) Open Circuit

Applies to: Whirlpool Electric / Convection Wall Oven & Range

The electronic oven control (EOC) detects an open circuit (resistance exceeding 2,500 Ω) on the oven temperature sensor (RTD) circuit.

BoschMaintenance
E011

Touch Sensor Keypad Stuck Fault

Applies to: Bosch Induction & Electric Cooktop / Oven

A touch key sensor on the glass ceramic control area has been continuously activated for more than 10 seconds, usually due to boiled-over liquids or a jammed capacitive pad.

SamsungCritical
SE

Membrane Keypad Short Circuit

Applies to: Samsung Over-the-Range & Countertop Microwave

The microwave control board detects a short circuit in the touch keypad membrane switch (key held down or stuck for more than 60 seconds).

GECritical
F350

Oven Temperature Sensor (RTD) Open Circuit

Applies to: GE Profile Electric Range & Wall Oven

Open oven temperature sensor circuit (formerly F3). The electronic range control (ERC) detects infinite electrical resistance across the resistance temperature detector (RTD) probe.

LGCritical
F9

Oven Maximum Preheat Time Exceeded

Applies to: LG ProBake Convection Electric & Gas Range

Oven preheat timeout error. The control board monitored cavity temperature during preheat, but temperature failed to exceed 150°F within 5 minutes or failed to reach setpoint within 30 minutes.

WhirlpoolCritical
F1E1

Electronic Oven Control Board EEPROM Error

Applies to: Whirlpool Electric & Gas Range / Wall Oven

EEPROM memory checksum error. The internal non-volatile memory of the electronic oven control (EOC) board has suffered data corruption or hardware gate failure.

Field Service Recommendations for Ovens, Microwaves & Cooktops

Prior to performing any diagnostic testing or taking electrical measurements on residential or commercial equipment, always lock out / tag out (LOTO) power sources and shut off fuel or water supplies. Wear rated personal protective equipment (insulated gloves, eye protection) and use a calibrated CAT III/CAT IV digital multimeter.

If fault symptoms persist after executing our pinout checks and component resistance tests, consult a factory-certified technician or licensed HVAC/appliance specialist.